COST SAVING PROCESS
LOW TEMPERATURE ALKALINE IMMERSION DEGREASING
To clean the oil grease etc from steel component
, there are so many process available
for us, which depends on oil layer ,application, finish requirement , suitability
etc but at present most popular process is alkaline immersion degreasing hot process, which require the bath
temperature between 50 to 90 degree centigrade .
To do the degreasing at the high temperature we face some problem like :
1. During
starting the process at morning time we
not able to get the high temperature of bath UNLESS we have to on the heater
with cut off system before of that day to achieve the bath temperature of
degreasing bath.
2. IF
we on the heater too much before the working time to get the specified
temperature THEN we are allowing the degreasing bath to consume more power .
3. Running
the degreasing bath at high temperature also bath will consume more power .
4. IF
by chance we not able to provide the specified temperature due to power cut or
any other reason then component will not clean proper .
To overcome the
above problem many degreasing chemicals manufactures developed the low
temperature alkaline immersion degreasing salt with better surfactant , which will be clean the oil, grease
etc from your steel component at low temperature ( 25 to 50 degree centigrade)
. By adopting this low temperature alkaline immersion degreasing process we can
avoid the tension of maintaining the high temperature of degreasing bath and
power bill also will reduce .
Related Post :
No comments:
Post a Comment